The hackin’toys midi board is a plug’n’play solution allowing you to build your very own midi controller
32 inputs
Class-compliant USB MIDI
USB C connector
Online editor (supported by Chrome or Edge)
Runs on Arduino pro micro, 5V
Supported components :
Any B10K potentiometer, faders, joysticks, modwheels
Switch or push buttons
Connections
JST PH2.0 connectors
left pin = +5V / middle pin = signal / right pin = ground
For buttons, use the middle and right pins only.
The online editor allows you to choose :
the type of each component (Note, CC, Program Change, Pitch Bend)
the value and midi channel of each component
This board does not support :
MIDI DIN connectors
Encoders
LED, screens, vue meters (any “MIDI in” feedbacks)
No soldering skills required if you use components from the hackin’toys boutique.
The hackin’toys midi board is a plug’n’play solution allowing you to build your very own midi controller
32 inputs
Class-compliant USB MIDI
USB C connector
Online editor (supported by Chrome or Edge)
Runs on Arduino pro micro, 5V
Supported components :
Any B10K potentiometer, faders, joysticks, modwheels
Switch or push buttons
Connections
JST PH2.0 connectors
left pin = +5V / middle pin = signal / right pin = ground
For buttons, use the middle and right pins only.
The online editor allows you to choose :
the type of each component (Note, CC, Program Change, Pitch Bend)
the value and midi channel of each component
This board does not support :
MIDI DIN connectors
Encoders
LED, screens, vue meters (any “MIDI in” feedbacks)
No soldering skills required if you use components from the hackin’toys boutique.